Paper space question...

I am new to Paper Space and have a question. Is there a way to create
objects in Paper Space (such as text) and not have it appear in Model
Space? I think that it must be since the Title Block that the wizard
inserts doesn't appear. I am using Acad R2000 on a 933MHz P3 with 512MB RAM.

TIA,
-GHB

 

Yes, that's the way it works. If you want to learn a bit more about using
paper space productively, see the tutorial at
http://www.turvill.com/t2/documents
___

 

You can make text any size you wish. I'm not sure where you're seeing the
"0.9" limitation. Normally text in paper space will be much smaller than
text in model space, since model space views are usually scaled. You *are*
setting up paper space to be plotted at 1:1, I hope. If you haven't read the
tutorial, do so; it explains the scalar relationships between model space
and paper space.
___

 

To what size do you set your cusor?

I always have it like the old way 100% this way when in a PS viewport you can see the cursor operating in that viewport only. When in the full PS mode you see a full cursor across the screen.

Terry
Thanks Paul. It was operator error!! I thought that I was in Paper Space when I was in fact in Model Space! (It is so easy to make that mistake.....

 

mistake.....

With the UCS icon ON you will never be confused. Look in the lower left
corner of the screen.