OCE, Reprodesk & AutoCAD 2005

Discussion in 'AutoCAD' started by donnieworld, Jun 29, 2004.

  1. donnieworld

    donnieworld Guest

    The OCE Cals driver produces great looking plots with AutoCAD 2000i but has many limitations.

    The LDF driver that OCE recommends for use with AutoCAD 2005 is producing poor results on screened contour lines.

    Does anyone have a recommendation for a good driver for OCE and AutoCAd 2005? The HP Deisignjet drivers don't produce acceptable results either...
     
    donnieworld, Jun 29, 2004
    #1
  2. donnieworld

    Doc Guest

    Donnie,

    Unless you are using a Reprodesk controller, you should be able to get good
    results from either the HDI driver (HPGL/2) for Oce or the Oce Raster driver
    (Windows System driver).

    Best Regards,
    Doc
    http://www.plotstream.com


    poor results on screened contour lines.
    2005? The HP Deisignjet drivers don't produce acceptable results either...
     
    Doc, Jun 30, 2004
    #2
  3. donnieworld

    Scott Sheppard Guest

    I work in Phoenix where the Océ LDF driver is produced. We get great results
    with it and Repro Desk. If you send a sample drawing to
    scott.sheppard@ocephx, we can look at it.

    poor results on screened contour lines.
    2005? The HP Deisignjet drivers don't produce acceptable results either...
     
    Scott Sheppard, Jun 30, 2004
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. te koop oce scanner, oce plotter en een HP kleuren plotter

  2. Lost Arch Sizes after installing reprodesk

  3. DL Reprodesk/Apprentice?

  4. OCE' 9400 and OCE' 9600 plotter setup for IV8

  5. Oce' Reprodesk's counterpart

  6. Plotting wipeouts on OCE 9600 w/Reprodesk

  7. OCE Reprodesk and PDFs

Loading...