nVidia FX 500 question

Discussion in 'SolidWorks' started by Richard Doyle, Jan 14, 2004.

  1. Richard Doyle

    Richard Doyle Guest

    An engineer just upgraded his system to a Dell with the FX 500 card
    replacing basically the same system that had a Quadro Pro (replace computer
    and monitor). Now he has RealView, but is also experiencing jagged lines in
    his displayed parts and assemblies. All settings are turned up to the max
    (image quality stuff), everything is fully resolved. The old system
    exhibited very smooth edges in parts and assemblies, but this one doesn't.

    Any ideas?

    Richard
     
    Richard Doyle, Jan 14, 2004
    #1
  2. Richard Doyle

    Dave H Guest

    Go To "Tools>Options>Display/Selection" and uncheck "Anti-alias edges"

    Dave H
     
    Dave H, Jan 14, 2004
    #2
  3. Richard Doyle

    Wayne Tiffany Guest

    Slip the Quadro into it and see if the problem goes away. This would prove
    it's the card and not something else on the new machine. Even though the
    machine should be "identical" they aren't really.

    WT
     
    Wayne Tiffany, Jan 14, 2004
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Quadro FX 500 drivers

  2. Quardo FX 500 or Quardo4 380XGL ?

  3. Video Card Question - Nvidia - SW tested cards and drivers

  4. nVidia Question??

  5. OT - HP DesignJet 500

  6. Anybody using Mutoh XP-500 plotter?

  7. nvidia fx3000 question

Loading...