Newbie Q: Making and using simple template.

Discussion in 'AutoCAD' started by Arty Flinders, Feb 25, 2004.

  1. Hi, I recently started an AutoCAD evening class. 3 hours per week isn't a
    lot of time, so I've been trying to make the most of it by producing a
    template based on my understanding of graphics packages in general.
    This may be a mistake, because things aren't working out too well at
    present.
    We're doing a series of exercises using a wide variety of Snap, Grid and
    Limits settings. Each new drawing has been started afresh by the method:
    File>New>Quick Setup> Units: Decimal> Area: to suit the individual
    exercise. The Snap & Grid have then been set as per the instructions for
    the drawing.
    Being a little slow I decided that I didn't want to start afresh each time
    but use objects and layers from previous drawings. So, each time I've dona
    a drawing I've added some of it to a developing template.
    Trouble is, now I come to use the template It doesn't seem to respond to
    new Limits, Snap & Grid settings. I imagined that I'd be able to completely
    overwrite the settings from the previous drawing by putting in new ones but
    having put in these new settings, the resulting work area is in no way the
    same as if I started a new file and put in the required settings from
    scratch.
    Can anyone please tell me if it's possible to clear a file's settings
    completely and put in new ones as though it was a completely new drawing?

    The instructor is using methods that require laborious repeating of setup
    processes on the basis that frequent repetition will drill the procedure
    into our memories. Unfortunately I just can't keep up by this method, hence
    the template idea.

    Regards,
     
    Arty Flinders, Feb 25, 2004
    #1
  2. Arty Flinders

    Lev Milchin Guest

    Use command LIMITS to reset drawing area.
     
    Lev Milchin, Feb 25, 2004
    #2
  3. I tried a new template after reading what you wrote and this new one
    responds to the settings changes, so it seems that you are right. Thanks a
    lot.
    Regards,
     
    Arty Flinders, Feb 25, 2004
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.