My Realview turned off

Discussion in 'SolidWorks' started by nixican, Oct 4, 2007.

  1. nixican

    nixican Guest

    I am running SW 2007 SP 3.0. I have a Quadro FX 1500. I have been
    using realview graphics for a while now and then all of a sudden, it
    stopped working (this morning). In SW, options, performance.... "Use
    Software OpenGL" is now checked AND grayed out. Can anyone provide
    any insight? I have tried reinstalling the 91.36 Forceware and have
    even tried 84.26.

    Im stuck and this is very frustrating.

    Thanks
     
    nixican, Oct 4, 2007
    #1
  2. nixican

    Joe Guest

    I am on version SW2006 4.0. But, perhaps you are not aware that to
    change the Software Open GL option, you must close out of any files
    first. If you have something open, the option is always greyed out.

    Joe Dunfee
     
    Joe, Oct 4, 2007
    #2
  3. nixican

    jburtonSW Guest

    you probably know this already but it is worth a try...

    Make sure you have nothing open in SW before going to system options
    as Software opengl will always be greyed out if you do.
    Close down all open documents and then you can untick it.

    Worth a try...
     
    jburtonSW, Oct 4, 2007
    #3
  4. nixican

    jburtonSW Guest

    ok... just noticed this has already been said... oops!
     
    jburtonSW, Oct 4, 2007
    #4
  5. nixican

    Dale Dunn Guest

    wrote in @r29g2000hsg.googlegroups.com:
    And if that doesn't work, a reboot may be necessary. I've been getting that
    a lot lately...
     
    Dale Dunn, Oct 4, 2007
    #5
  6. nixican

    nixican Guest

    Thanks for the replies. I had to update my SW 3.0 to SP 3.1. There
    must have been some driver or something that got mucked up somehow.
     
    nixican, Oct 4, 2007
    #6
  7. nixican

    nixican Guest

    Thanks for the replies. I had to update my SW 3.0 to SP 3.1. There
    must have been some driver or something that got mucked up somehow.
     
    nixican, Oct 4, 2007
    #7
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.