Modifying grips

I'm not sure if this is a question for the VBA group or the general Acad group, but here goes...

Is there any way to make the predefined grips for an entity different using VBA? For example, say I make a box (solid) which then has its standard 6 grips (one at each corner). But instead of these typical 6 grips, I would like the user to only be able to select a grip that is equivalent to the centroid of the solid (say like a sphere solid). Is this at all possible??

Thanks

DRW

 

No

using VBA? For example, say I make a box (solid) which then has its
standard 6 grips (one at each corner). But instead of these typical 6
grips, I would like the user to only be able to select a grip that is
equivalent to the centroid of the solid (say like a sphere solid). Is this
at all possible??