modal

Discussion in 'Pro/Engineer & Creo Elements/Pro' started by crazy PRO, May 3, 2004.

  1. crazy PRO

    crazy PRO Guest

    Hi,
    I'm working on a modal analysis of an assembly. When I make this
    analysis on structure only I'm sure about results, but if I try to put
    on datum point a center of mass, I'm not sure.
    Is it a correct way to work? It is a correct idealizzation?
    Althought, what is the right way to represent real mass on structure?
    Thanks a lot in advance
     
    crazy PRO, May 3, 2004
    #1
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.