Metal Spinning

Discussion in 'SolidWorks' started by JKimmel, May 2, 2006.

  1. JKimmel

    JKimmel Guest

    Can anyone recommend a metal spinning company that can do parts up to
    about 3' diameter? This is for bell mouth engine inlets.

    Thanks,
    --
    J Kimmel

    www.metalinnovations.com

    "Cuius testiculos habes, habeas cardia et cerebellum." - When you have
    their full attention in your grip, their hearts and minds will follow.
     
    JKimmel, May 2, 2006
    #1
  2. JKimmel

    Art Woodbury Guest


    O.W. Landergren Co., Pittsfield, Massachusetts

    http://www.owlandergren.com/
     
    Art Woodbury, May 2, 2006
    #2
  3. JKimmel

    rmontminy Guest

    Bomco in Gloucester, MA
     
    rmontminy, May 2, 2006
    #3
  4. JKimmel

    John Layne Guest

    John Layne, May 3, 2006
    #4
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Metal/Wood Stud Generation routine....

  2. New for Sheet Metal Desingners and Workers

  3. Some offset between the metal interconnection and cells from Sillicon Ensemble to DFII Design Enviro

  4. Does the Encounter only deal with the process more than two metal layers?

  5. Creating Vias between metal layers

  6. How to remove a metal layer '("M2" "D0") recursively in a top level block (layout)

  7. Wildfire Spinning Panning Rotating

  8. Spinning vs Deep Drawn

Loading...