Matlab data types in AMS-Designer

Discussion in 'Cadence' started by Taimur, Jun 28, 2008.

  1. Taimur

    Taimur Guest

    Is there any consideration about the data type shall be used in Matlab
    co-simulations with AMS? Continuous signals? Discrete signals? If so,
    which sample rate? Thanks in advance.
     
    Taimur, Jun 28, 2008
    #1
  2. Taimur

    Andrew Beckett Guest

    Taimur wrote, on 06/28/08 18:14:
    Best thing here is to read the manual.

    Using a recent version of IUS which supports AMS (e.g. IUS611 or IUS81, for
    example), start "cdnshelp", and search for "simulink". Note that you cosimulate
    with simulink (rather than vanilla Matlab).

    There's a chapter in the Virtuoso AMS Designer Simulator User Guide (Chapter 14
    in the version I checked) called "Cosimulation with Simulink and AMS Designer" -
    and a section within that on Coupler Modules which describes the data types and
    how synchronization is done, what sampling is done and so on.

    Regards,

    Andrew.
     
    Andrew Beckett, Jul 1, 2008
    #2
  3. Taimur

    Taimur Guest

    Thanks, again.
     
    Taimur, Jul 3, 2008
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. xrecords and types of data

  2. ams designer missing libvpi.so and libpli.so?

  3. AMS Designer & nlAction

  4. AMS Designer tcl script mode determination?

  5. VHDL-Ams AMS Designer

  6. CADENCE-MATLAB DATA TRANSFER

  7. config cellviews in Hierarchy Editor vs. VHDL configurations for AMS Designer i.e. ncsim

  8. AMS Designer Setup

Loading...