Mate References - no assy to assy

Discussion in 'SolidWorks' started by SR, Jan 20, 2004.

  1. SR

    SR Guest

    With regards to mate references, online help it states you can define
    "Multiple mated entities". Each mate reference can contain up to three
    mated entities. Each of these entities can have an assigned mate type
    and alignment.

    For example, a shaft can have its cylindrical face assigned to a
    concentric mate and its planar end face assigned to a coincident mate.
    When you drag that component into an appropriate location in an
    assembly, the software adds both mates.

    This appears to be true when only adding a part (with mate refs) to an
    assy (with the same mate refs), but it DOESN'T work for adding a
    sub-assy (with mate refs) to an assy (with the same mate refs).

    Has anyone else seen/confirmed this before?
     
    SR, Jan 20, 2004
    #1
  2. SR

    Krister L Guest

    This is true if You try to drag a sub assy from another window.....but You
    can like this.... if You're in SW 2004...drag the subassy in the the main
    assy...drop it anywhere ...pick (for example) a cylindrical edge...hold down
    alt key and drag it to another cylindrical edge and You'll have a "multiple
    mate"....cylindrical and coincident

    Krister L

    SR <> skrev i
    diskussionsgruppsmeddelandet:
    ....
     
    Krister L, Jan 23, 2004
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.