Hi, I am currently using 2000, but will be moving to 2007 in a few weeks. One thing I have always wanted to do, but never found a way to do it is "mask" a part of the drawing. For example: If I draw a floor plan on layer 1-wall, I would like to mask off a section of this floor plan and draw an alternate bath on alt-wall, or even a second floor over the 1st floor "masked" area. Ideally, it would mean drawing a pline and telling autocad to "mask" the layers inside the area. anyway...does somethign like this exist in newer versions? I also read an article a very very long time ago that used a 3d object? to "mask" and area? I have not been able to find a refrence to that, and do not remember how it was done. Thanks all for your help, Jojo