making two lines intersect.

Discussion in 'SolidWorks' started by Nathan Feculak, Dec 9, 2003.

  1. Nathan Feculak

    Nathan Feculak Guest

    If you have two lines that you want to intersect (extend to each other) how
    do you do it. When you use the extend tool on the sketch tool bar it won't
    make them intersect unless there is a line for it to extend to. I seen
    people in demos do it but I can't figure out how to do this.
     
    Nathan Feculak, Dec 9, 2003
    #1
  2. Nathan Feculak

    Nathan Feculak Guest

    Thanks Guys, I tried your way Dale and that was exactly what I was looking
    for.
    What does LMB sand for?
     
    Nathan Feculak, Dec 9, 2003
    #2
  3. Nathan Feculak

    bob zee Guest

    Left
    Mouse
    Button

    much different than the typical LMB that bob z. is known for...
     
    bob zee, Dec 9, 2003
    #3
  4. Nathan Feculak

    N. Jones Guest

    as opposed to RMB......... :)

    Noel
     
    N. Jones, Dec 9, 2003
    #4
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Finding intersect of a chamfer

  2. lisp INTersect lines and arcs

  3. Polyline intersect itself

  4. Surface Intersect

  5. intersect with block problem

  6. Intersect part with feature error

Loading...