macro problems

Discussion in 'SolidWorks' started by dbq, Nov 5, 2004.

  1. dbq

    dbq Guest

    I created a macro to change the arrow parameters in draw mode and it
    worked fine. I was also able to set the Linear Dimension Precision
    within the same macro and it worked as well (though
    AltLinearDimPrecision did not work). My main problem however was with
    my attempt to set the Annotations Font under Document Properties. I
    could not create a macro for either Note, Dimension, Detail or Section
    under Annotations Font. When I went to edit the macro, the macro was
    essentially empty. Has anyone run into this before?

    TIA

    Paul
     
    dbq, Nov 5, 2004
    #1
  2. dbq

    Evan T. Basalik Guest

    There are TONS of things the macro recorder won't pick up. I would
    recommend looking under the system options in the API help. Annotation font
    should be under there.

    Evan
     
    Evan T. Basalik, Nov 8, 2004
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. dimension macro

  2. Can't enter printer name in macro

  3. ACAD LT 2004 macro problem

  4. Need toolbutton macro for layer toggle

  5. Macro problems

  6. Call a macro from another macro?

  7. Macro to rerun a macro

  8. Is it possible to run a macro file from another macro file?

Loading...