M11 x 1.5 in Hole Wizard - Not

Hello All,

Sorry if this has been asked before, but I couldn't find it.

I have the need to create a hole using Hole Wizard that is a metric tap size
M11 x 1.5, but Hole Wizard has only M10 and M12.
So my question:
Can I somehow set up hole wizard to show a M11 x 1.5 hole by "tweaking" the
Hole Wizard file (whatever & wherever that is)?
Or, is there a better way to do this?

TIA,
Muggs

 

???? M11 ????
I've been in metrics all my life and never seen one. The standard is M10
(x1.5) and M12(x1.75), why add one you will not find any tool to make?

 

Use legacy

 

See the M11 x 1.50 tap ......
http://mdmetric.com/mosale/tds110.htm

HTH

 

Jean Marc,
Thanks for your "insight", I realize that it is a non standard tap size, but
come on, don't embarrass yourself by saying "you will not find any tool to
make".
McMaster-Carr has more than enough for both of us IN STOCK (Page 2240 of
their latest catalog).
This is for an intake manifold for a VW VR-6 and the mass air sensor is a
STANDARD 11 x 1.5 thread.

Muggs

 

OOPS, it's not on my '1967 Omaro thread slider... And not on any tool
catalog I've read.

Thanks, I can now say "I know were there is a M11 thread". I would never
imagine the need of an intermediate between M10 and M12.
I get it: I must be to prevent from putting a standard screw in there.

Anybody knows a 1/3 inch thread? Don't want to be stupid on that one.

 

Great! Thanks Ricky and All.

Muggs