LVS Error: No matching ".SUBCKT" statement for "rhrpo_ckt_rf" at line .....

Discussion in 'Cadence' started by ykjing, May 19, 2008.

  1. ykjing

    ykjing Guest

    Hi,
    I have run assura LVS for a LNA circuit, which has RF componets, and the
    result said it match its schematic. But I run Calibre LVS for the same LNA
    circiut, there are " Error: No matching ".SUBCKT" statement for
    "rhrpo_ckt_rf" at line... and " source could not be read".
    Only RF components have above error, other component can be recognized.
    Can someone kindly tell me how to solve the error.

    Thank you in advance.
    Regards.
    Fred.
     
    ykjing, May 19, 2008
    #1
  2. ykjing

    Muzaffer Kal Guest

    Check how the RF component netlist files are included in the source
    spice file. Calibre takes a single source input which has to include
    all the necessary subcircuits. Make sure that all the included files
    are accessible from the folder in which you are running Calibre; it's
    possible that the include paths are no longer valid if you've moved
    the source spice file to run Calibre.
     
    Muzaffer Kal, May 19, 2008
    #2
  3. ykjing

    ykjing Guest

    Dear Muzaffer Kal,

    Thank you for you help. The problem solved. I asked our foundary for the rf
    netlist and included them into my source file, as you said.

    Thank you again.
    Best Regards.
    Fred.
     
    ykjing, May 23, 2008
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.