loadpull simulation for PA

Discussion in 'Cadence' started by pureck, Apr 27, 2005.

  1. pureck

    pureck Guest

    hello

    i am working on a PA and tried to figure out how the portAdapter works
    in loadpull simulation.
    There is an example in rfExamples library and PA application note says
    the portAdapter does the loadpull simulation.
    i want to find out how the parameters of the portAdapter relate each
    other. For example, how those phase of gamma and mag of gamma produce
    capacitance, inductance and resistance values.
    It will be very much appreciated if anyone can help on this.

    thanks.
     
    pureck, Apr 27, 2005
    #1
  2. pureck

    Andrew Beckett Guest

    Did you read the SpectreRF User Guide? Chapter 11 covers simulationing load
    pull contours, and explains how to set this up using the portAdapter.
    (In case it isn't chapter 11 in the version you're using, it's the chapter
    called Modeling Transmitters)

    Regards,

    Andrew.
     
    Andrew Beckett, May 3, 2005
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. SKILL Q: Getting simulation result for selected instances in schematic

  2. how to use "adc_dnl_8bit" for DNL simulation?

  3. How to create inductor cell for simulation and LVS?

  4. Question about a warning message in PSS+PNOISE simulation for LC VCO

  5. pre-layout simulation for lsi_10k netlist using ncvhdl

  6. advance simulation time without running simulation and then re running

  7. to netlist a device for CDL but not for simulation

Loading...