Linear slide screw, will a gear mate do this?

Discussion in 'SolidWorks' started by Ben Eadie, Nov 15, 2004.

  1. Ben Eadie

    Ben Eadie Guest

    So there are gear mates, This is stretching it I am sure, but, a linear
    slide screw configuration for this? Or does any one know how to mate a
    screw that turns 4 times for one inch of linear travel. It will make a
    animation for me alot easier. I am on 2004 SP4.1 (I will be doing the 2005
    thing as soon as my clients do...So I can use 2005 if nessasary.

    Ben
     
    Ben Eadie, Nov 15, 2004
    #1
  2. Ben Eadie

    MM Guest

    MM, Nov 15, 2004
    #2
  3. Ben Eadie

    Ben Eadie Guest

    Cool thanks, I was hoping to have less geometry and not have a helix.. but
    this is better than where I started.

    Ben
     
    Ben Eadie, Nov 15, 2004
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. This will undo everything. OK?

  2. I'm learning so be nice, this will be easy

  3. what does this warning meanin simulation mixer:"relative residual ofthe linear system is significant

  4. Linear Sketch vs Linear Pattern

  5. Source for drywall screw files or wood screw

  6. This beginner has a mate problem.

  7. Linear-Linear coupler mate

Loading...