LIMIT MATES...again

I have a part that pivots on an axle in my assembly. Its travel is limited
by two surfaces it comes in contact with, one on each end of the travel.
How do I set this up using the advanced mates. I don't see an option for
picking the two surfaces. Any help will be appreciated.

 

Don't confuse the "collision detection" with "limit mates". Limit mates
work by specifying a range of distance/angle through which a part can
move, they don't have anything to do with contact. The best thing might
be to use the "collistion detection" to determine where the contact
happens, and then hard key those numbers into the limit mate using
either a distance or angle mate. This is usually done by planes, but
you can use planar surfaces or anything else you can make a distance or
angle mate between.

Good luck,

Matt