length constraints across components

Discussion in 'Cadence' started by n1ist, Sep 2, 2006.

  1. n1ist

    n1ist Guest

    I'm running 15.5.1 and I need to set up a length constraint acoss a
    path that includes active components (ie. I have 2 paths that need to
    be matched; each has 2 buffers in it). If I match each section against
    the corresponding section in the other path, I get a good length match
    but the total length is far from optimal. Is there any way to
    constrain the sum of path lengths (like an XNET but for actives)?

    Thanks.

    /mike

     
    n1ist, Sep 2, 2006
    #1
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Pro-Mechanica Constraints

  2. Component Connections constraints Flipping at Random!?

  3. Re-ordering constraints

  4. component constraints on old family table parts

  5. CHECKING CONSTRAINTS

  6. SW2005 Splines, warnings or over constraints?

  7. Getting Components and then getting mass properties info from those components sequentially

  8. Constraints to Projected curves

Loading...