@ Kitchen Cabinets

Discussion in 'AutoCAD' started by Lo, Jan 27, 2005.

  1. Lo

    Lo Guest

    Hello There:

    I will start a job soon where they use AutoCad,
    they are cabinet makers.
    I was wondering if anyone in this group has basic kitchen cabinet drawings
    so I can get somewhat familiar with it before I go to my new job.

    Thank you in advance.

    Lo

    Please remove nospam to reply
     
    Lo, Jan 27, 2005
    #1
  2. Lo

    teiarch Guest

    Not knowing what country you're in, hard to make suggestions. In the US, visit a home center such as Home Depot, Loewes, etc, and browse the cabinet department with a tape measure and sketch pad.

    Go on line and do a search on Google for manufactured cabinets and down load CADD files if available.

    Go to the web site of the AWI, American Woodworking Institute and browse their standards. Most custom cabinet makers in the US manufacture their products following AWI standards.

    Hope this helps and good luck in your new job.
     
    teiarch, Jan 28, 2005
    #2
  3. Lo

    RickW Guest

    If you can find a copy of an old Architectural Graphics Standards or Time-Saver Standards (new ones are pretty expensive) there is a lot of usefuly information in those.
     
    RickW, Feb 17, 2005
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.