Anyone know of a way?
Sure. Go to Tools/Customize/Keyboard/Edit category. In the commands box go to Roll to End and assign you key. WT
Duh!!! I didn't see it there before I posted the question. But I think I just figured out why it wasn't there. I didn't realize this until now, but the commands that the "Customize>Keyboard" lists, depend on what type of document is active at the time you click Tools>Customize. In my case, I had a drawing document active when I clicked Tools>Customize. The "Roll to End" command was not listed, at all. I have played around with it a little and figured this out. Some commands will show up in this list regardless of what type of document is active at the time (new, open, etc). Some commands will only show up in the list if a part is active (fillet, chamfer, etc). Some commands will only show up in the list if an assembly is active (reload, replace, etc). And then some commands will only show up in the list if a drawing is active (hide/show annotations, next sheet, etc). In other words there is no way to view ALL system wide available keyboard commands at the same time. I didn't know that. That SUX.
Yes, I found that also. See my new post about the list - I checked through it with all 3 documents active. WT