ISOMETRIC SECTION IN DRAWINGS

Is there a way to show an isometric section in a drawing view?

In 2004 I have saved some section views from the isometric view point. I
wanted to insert them into a drawing but when I do the entire model is shown
isometric with no section cut.

Is there or has there been away to show a view like this in a drawing?

 

Unless something changed in 2004 that I didn't hear about or forgot, no. I
think you've got two choices. You can make an iso view in your drawing, then
section it. (I've never done this, but it seems like it should work OK.) Or
you can make a configuration where you cut your part or assembly in the same
manner, then place a view of it in your drawing.

Jerry Steiger
Tripod Data Systems