insert object (excel)

Discussion in 'SolidWorks' started by dbq, Oct 22, 2004.

  1. dbq

    dbq Guest

    I'm using SW2004. Tried to insert an object into a drawing (not
    linked). The object was an Excel spreadsheet. I found it to be hit
    or miss. There were 8 columns and 12 rows in this spreadsheet. Just
    once I got all rows and columns to show up. On subsequent attempts,
    only the first few of either the rows or columns would show. In other
    words, the spreadsheet was truncated (pulling on the handles of the
    table in SW only made the column and row widths larger). I could not
    figure out what went wrong. Any suggestions?

    Related question: how do you make a blank table in SW and how would
    you add/subtract rows/columns from this blank table?

    TIA

    Paul
     
    dbq, Oct 22, 2004
    #1
  2. dbq

    kmaren24 Guest

    Do it as a design table (if you can). Even though it doesn't drive
    anything it will be easier to place and control what cells you want to
    see.

    Ken M
     
    kmaren24, Oct 22, 2004
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.