Incorrect Display of Countersink Holes, SP3

Discussion in 'SolidWorks' started by Devon T. Sowell, Jul 21, 2004.

  1. Devon T. Sowell

    Devon T. Sowell Guest

    2004 SP3
    Conditions; Hole Wizard used to create a countersink hole with the following
    edits
    1. Head Type & Clearance .xxx
    2. Increase C'sink
    I use this edit to assure that the heads of screws do not protrude past the
    surface, usually I add .005".
    In the part model file, the diameter is correctly increased.
    In the drawing file of this part, when the Hole Callout is used, the
    incorrect value is displayed. The default diameter is displayed rather than
    the correct increased diameter.
    The work around is to manually edit the annotation.
    Best Regards,
    Devon T. Sowell
    www.3-ddesignsolutions.com
     
    Devon T. Sowell, Jul 21, 2004
    #1
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Incorrect Object Visibility

  2. Analog Environment - Subcircuit degeneration - incorrect node naming

  3. model tree displays incorrect model

  4. Countersink possible w/ straight holes in WF2?

  5. Small Holes Continued (On Thousands of Holes)

  6. Hole wizard countersink incorrect?

  7. Incorrect Selection Set objects

  8. Dimensions Incorrect

Loading...