importing dxf into assembly as sketch

Discussion in 'SolidWorks' started by Steven, Jan 21, 2004.

  1. Steven

    Steven Guest

    Is there a simple method of importing a dxf drawing directly into an
    assembly tree (to be used as a layout sketch)? The help refers to importing
    into parts only- it doesn't work for assemblies.

    TIA,

    Steven
     
    Steven, Jan 21, 2004
    #1
  2. Steven

    Klaus Sabroe Guest

    Hi Steven

    When I open the dxf SW asks if it shall open in a drawing or in a
    part/sketch.
    I always open in a part and this is the first part in my assembly. I
    give it a dummy name/number and then i have no problem with my bom.

    Kind regards

    Klaus
     
    Klaus Sabroe, Jan 21, 2004
    #2
  3. Also

    If you have AutoCad on your system you can open the dxf there and cut and
    paste into any SW sketch.

    Regards
    Corey
     
    Corey Scheich, Jan 21, 2004
    #3
  4. Steven

    Chris Guest

    could you use a skeleton part?

    Chris
     
    Chris, Jan 21, 2004
    #4
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.