impeller with design table

Hi

I need to model an impeller using a table of coordinates of the
centerline of the vanes. table colums are "R" "THETA" "Z" &
"thickness". Anyone have any idea or a design table that has already
done this?

thanks
Gary

 

This shouldn't be difficult, Gary, depending on how complex the profile
of the vanes needs to be. I have an impeller design in which the vanes
are created from a loft between two ellipses. It would be quite easy to
create a Design Table to vary the profile (angle, thickness, center
location, etc.). If you want me to create one for it and send it to ya
just email me or reply to the post and be a little clearer about your
variables. I understand THETA and "thickness", but I'm not sure about R
and Z. You can find a valid email for me on my Web site, or just
unMUNGE the address in the header.

Mark 'Sporky' Stapleton
Watermark Design, LLC
www.h2omarkdesign.com

 

Thanks Sporkman

One of my coworkers thinks he has it figured out, if he does get it
I'll get back to you.

thanks
Greif