HP DesignJet 650C misses the ends of arcs and lines

Discussion in 'AutoCAD' started by Stephen R. Collier, May 20, 2004.

  1. Our HP 650C tends to not completely print arcs or lines all the way to the
    end. It only occurs on some of our lines/arcs on circuiting drawings. The
    plot preview shows the complete line. I've updated to the latest
    Win2000/650C drivers.

    The only thing that might have an effect on this in the drawings (I need to
    check this), is that I use points on the defpoints layer in my blocks for EZ
    circuiting. I keep PDMODES set to 0 so it's just a dot on screen.

    Anyone run into this one or have any ideas?

    - Stephen
     
    Stephen R. Collier, May 20, 2004
    #1
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.