HP 330 (A0/E) & Autocad LT 2005

I have a plotter HP 330 (E/A0) and I have problems printing with rulls.
I try to print a rull that is 914 mm but the plotter prints only 840 mm. In
the print preview I can see all the area I want to print but the real
printed area at the end is only 840 mm.
I have the last drivers for win xp (v. 4.65) that are in the Autocad's CD.
Is there someone who could help me?

Thanks

Guido

 

Inked Area is always disabled... I can't turn it on or off!!!
Thanks a lot for your answer.
Guido

 

I downloaded the latest drivers from hp's site but nothing to do!!! The
same! If I try to print on 910 mm. rull it prints only 840 mm. If I use a
610 mm. rull it prints only 590 mm. The inked area is always disabled and I
can't turn it on or off!
It's a big problem because I can't print!!! I tried to contact the autodesk
but... no answer at the moment... any idea??

Really thanks for your help Dean!!!

Guido

 

Solved!!!! The problem was in the plotter configuration. Don't ask me why,
but in the plotter configuration was setted a strange format of paper... The
strange thing is that before Autocad LT 2005 I didn't find probles...

So, if someone has problems like this, try to print (read the instructions)
the plotter configuration to see the parameters inside the plotter. The
driver that you install can't change the plotter's configuration and
probably may conflict with it.

I want to thank again Dean for his/her help!!!

Guido