How to draw holes on cylinder

Discussion in 'SolidWorks' started by Ming, Oct 14, 2004.

  1. Ming

    Ming Guest

    Hi There,

    How can I draw 3 holes on cylinder with 120 degree even space?

    Thanks a lot,

    Mi
     
    Ming, Oct 14, 2004
    #1
  2. Ming

    Corey Scheich Guest

    Create a plane to draw hole one on if you don't already have it draw and
    extrude or revolve if it is a complex hole then circular pattern around the
    temporary axis of the cylinder. pick 3 with equal spacing. Or type 120 in.

    Corey
     
    Corey Scheich, Oct 14, 2004
    #2
  3. Ming

    ming Guest

    Thank you Corey. Per you instruction. I was able to draw it out.

    Again, Thank you for your help.

    Mi
     
    ming, Oct 14, 2004
    #3
  4. Ming

    Spud Guest

    Hi
    Insert a plane on the axis of the cylinder and the a further two more at 120
    degree angle. Use each plane as your sketch plane and sketch your hole (or
    use hole wizard) then extrude to the surface of your cylinder.

    good luck
    Spud
     
    Spud, Oct 27, 2004
    #4
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. How to add holes table into drawing

  2. How can I combine rectangular holes in the hole table?

  3. Holes on a cylinder

  4. How to mate a cylinder and a cube

  5. Small Holes Continued (On Thousands of Holes)

  6. How can I get tapped holes

  7. How can I create a disc with a random amount of holes on a boltcircle diameter?

  8. smooth 3d cylinder --- How?

Loading...