hole size and design table

Discussion in 'SolidWorks' started by Jacob Filek, May 1, 2004.

  1. Jacob Filek

    Jacob Filek Guest

    How do I control the size of a Hole in a Design Table:

    i.e. :

    config1 has 5/16-18 C'bore
    config2 has 3/8-16 C'bore
    config3 has 1/2-13 C'bore

    would I have to add all the holes a suppress the ones i need or
    can i control the size thru a design table?
     
    Jacob Filek, May 1, 2004
    #1
  2. Jacob Filek

    cadishaq Guest

    you can control the dimensions of your hole with a design table. But
    that is asking for trouble if you used the hole wizard to place your
    hole. If you did, then it would be better to suppress / activate your
    hole with the design table.


    Respect,

    CS
     
    cadishaq, May 1, 2004
    #2
  3. Jacob Filek

    Seth Renigar Guest

    Jacob,

    I do this quite often. But, when I do have a need for a design table to
    drive hole sizes, I always use a legacy hole type and use the dimensions of
    the hole in the design table. Keeps it simple. Although you must manually
    decide clearance sizes, hole depths, c-bore depths, etc. instead of using
    the defaults like in the other hole types.
     
    Seth Renigar, May 3, 2004
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.