hole callout question

Discussion in 'SolidWorks' started by Marco Flores, Jul 29, 2003.

  1. Marco Flores

    Marco Flores Guest

    I have a 8 taps 1/4-20 in my drawing. I made them by the hole wizard.

    In the drawing I use the hole callout and this appears [ Ø.201 thru all
    1/4-20-UNC -2B ?.500], and I want to change this kind of call out to [
    1/4-20 Tap x .500 deep (8x)]

    Is possible to do that, I want that every time that I want to use a
    callout for the taps always obtain this configuration.

    Regards.
    Marco
     
    Marco Flores, Jul 29, 2003
    #1
  2. Marco Flores

    Marco Flores Guest

    OK, Joe thanks for your help.

    Marco.




     
    Marco Flores, Jul 30, 2003
    #2
  3. Marco Flores

    Marco Flores Guest

    Joe, do you know how to change the description from lowcase to
    uppercase.

    Ejm.
    CBORE #10 Socket Head Cap Screw.

    to CBORE #10 SOCKET HEAD CAP SCREW

    Regards.
    Marco Flores.





     
    Marco Flores, Jul 30, 2003
    #3
  4. Marco Flores

    Michael Guest

    the easiest way is to use an all caps font (e.g.-- Technic). Then it
    doesn't matter....


     
    Michael, Jul 30, 2003
    #4
  5. Marco Flores

    Marco Flores Guest

    I tried changing the font to Technic as Michael suggest me, and it works
    good, I think the hard way is going to be more complicated and very risky, I
    will keep the easy way and the hard way I will practice in the future.

    Thanks for your support.
    Marco
     
    Marco Flores, Jul 31, 2003
    #5
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.