HOL files depth values?

Discussion in 'Pro/Engineer & Creo Elements/Pro' started by g.ormesher, May 19, 2005.

  1. g.ormesher

    g.ormesher Guest

    Hello

    I'm trying to modify a .hol file.

    When an M6 x 1.0 hole is used the defaults are 12mm thread depth & 15mm
    hole depth.

    These two values dont appear in the M6 x 1.0 ISO.hol file.

    Hoe does Proe WF2 arrive at these values?

    Thanks

    Geoff
     
    g.ormesher, May 19, 2005
    #1
  2. g.ormesher

    Jason L Guest

    I think that it uses a percent of the thread depth which is 65% in the .hol
    files that come with Pro/E. In my opinion it is safer to use 1X the thread
    diameter (100%).
     
    Jason L, May 20, 2005
    #2
  3. g.ormesher

    g.ormesher Guest

    Thanks, I believe its a in built formula, so I'll just have to change
    the values once the hole is placed

    Geoff
     
    g.ormesher, May 23, 2005
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Showing Z-depth info

  2. I'm out of my depth - please help!

  3. showing z-depth info within dimensioning

  4. Logic Depth Dependent Synthesis

  5. Problem with setting active depth

  6. Unified Back/Depth Buffer & NVIDIA RIVA TNT2 64

  7. .hol files and formatting thread notes

  8. Drawing table values linked to values in design table?

Loading...