highlighted edges in drawing SW2007 SP3

Discussion in 'SolidWorks' started by Bill, Mar 20, 2007.

  1. Bill

    Bill Guest

    I no longer have edge, lines, circles, etc. highlight in red when I
    hover the mouse over them in a drawing. It worked on SP2.1 but it is
    gone in SP3. It happens even with software opengl checked.

    Anyone else see this?

    DELL M90
    4 gb ram
    Quadro FX 2500 Go

    Thanks,
    Bill
     
    Bill, Mar 20, 2007
    #1
  2. Bill

    Wayne Tiffany Guest

    Check both settings for dynamic highlight.

    Tools/Options/System Options/Display/Selection/Dynamic highlight from
    graphics view
    Tools/Options/System Options/FeatureManager/Dynamic highlight

    These seem to have a habit of turning off by themselves.

    WT
     
    Wayne Tiffany, Mar 20, 2007
    #2
  3. Bill

    Bill Guest

    Thanks that was it. "Tools/Options/System Options/Display/Selection/
    Dynamic highlight from graphics view" was unchecked.
     
    Bill, Mar 20, 2007
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. VLISP Error Trace: De-highlighted Right Click Source Position and Call Point Source

  2. Pressing F1 when a menu item is highlighted

  3. How can I get the nets which had been highlighted through SKILL?

  4. panning drawing slow when items are highlighted

  5. Shaded With Edges Mode Problem in SP3.0

  6. Edges, edges, edges

  7. SW2007 sp3.1 CRASHES with one flange!

  8. RE RE SW2007 sp3.1 CRASHES with one flange!

Loading...