hem does not unbend

Discussion in 'SolidWorks' started by arif, Mar 17, 2007.

  1. arif

    arif Guest

    I used to be able to unbend hems in 2006. I lost it in 2007 (pun
    intended). I am at sp 2.1 . Is it me, am I missing a step, or are
    there others w/ this problem? Thanks.

    ---
     
    arif, Mar 17, 2007
    #1
  2. arif

    WT Guest

    I just tried a sheet metal part that consisted of the base flange and
    a hem, and when I hit the flatten button, it flattens. Is this what
    you are doing and do you not get the same results?

    WT
     
    WT, Mar 17, 2007
    #2
  3. arif

    arif Guest

    Sorry about the late reply.. I found out that if I use a K-Factor with
    the hem, it unbends properly. If I use BA,BD, etc.. it unbends but
    does not show the length past the hem. So, I used a K-Factor for the
    part with the hem. Thank you for looking into this for me.

    AO
     
    arif, Mar 23, 2007
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Why does Entlast not work?

  2. bad argument value: does not fit in word

  3. lisp command does not run even though loaded

  4. SOS! SAVE ME! cdsSpice could not extract netlist: ERROR: NODE/NET IS NOT ON KEEP LIST AND NOT IN WSF

  5. Unbend -- IGES Sheet metal

  6. sheetmetal "unbend" command question. The button is gray.

  7. Cant unbend this part, seem like a no brainer

Loading...