help with NCSU DESIGN KIT

Discussion in 'Cadence' started by aditya, Jun 15, 2004.

  1. aditya

    aditya Guest

    Hi,

    I am using NCSU CADENCE design kit for my design . I put a layout of
    1200 Ohm resistor but when I try to extract the extracted netlist
    doesnt show the resistor . I used all the methods (putting res_id etc)
    listed on the ncsu website but cant extract the resistor . In the
    extraction dialog box there is no switch specified for extraction of
    drawn resistor or capacitor .


    How do I extract a resistor??????


    with regards
    aditya
     
    aditya, Jun 15, 2004
    #1
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. About ASSURA and HIT-KIT 3.40

  2. Simulating in Cadence a D-latch cell DL8 from AMS 0.6 Hit-Kit

  3. installing NCSU for linux

  4. AMIS ADS Design kit on Solaris 10 Sparc

  5. Design Kit AMI 0.35um , Netlisting Problems

  6. Use NCSU kit With Assura

  7. SolidWorks Student Design Kit

  8. SolidWorks Student Design Kit Problem!!!

Loading...