help, hole center lines to follow bolt circle

Discussion in 'SolidWorks' started by pie, May 22, 2006.

  1. pie

    pie Guest

    In SW drawing, it automatically puts coordinate type center lines for
    the thru holes as if you are using coordinate dimensions. How do you
    change the type of the center lines so you can use bolt circle to
    locate these holes - meaning the hole center line is curved (not
    straight) to follow the bolt circle or circle center.

    Thank you.
     
    pie, May 22, 2006
    #1
  2. pie

    Reaper2561 Guest

    Pie, I run SW2003, but under center lines/options, there are choices
    for single/linear/circular. I choose circular.

    Reaper.
     
    Reaper2561, May 22, 2006
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.