Helix Configuration

Discussion in 'SolidWorks' started by krupnikas, Sep 5, 2003.

  1. krupnikas

    krupnikas Guest

    What would be the parameter to enter in a design table that would allow me
    two configurations of a screw elemeent? One helical path for a clockwise and
    the other configuration being counter-clockwise.
     
    krupnikas, Sep 5, 2003
    #1
  2. krupnikas

    Corey Scheich Guest

    I'm not sure if that is possible, but you can create 2 features, one for
    clockwise and one for counter clockwise. Then you just controll the
    suppression state of them
     
    Corey Scheich, Sep 5, 2003
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. how to make a flat helix curve in Pro/e

  2. helix

  3. Helix with variable pitch

  4. How to make an Helix over a 3D spline

  5. sweep a helix along a guide spline

  6. Getting a helix to sweep around

  7. Helix

Loading...