hatch connected to layer?

Discussion in 'AutoCAD' started by Jan van de Poel, Feb 24, 2005.

  1. Recently I saw a guy using autocad with a miraculously hatching.

    He drew a rectangle on a layer, f.i. Brick, and instantly this rectangle was
    hatched appropiatly.
    The same worked if he drew a polyline figure.
    As long as the figurine is closed, it works.

    Wonder if anyone has seen such a routine or trick to get this done.

    Regards,
    Jan
     
    Jan van de Poel, Feb 24, 2005
    #1
  2. Jan van de Poel

    R.K. McSwain Guest

    Yes, the MPOLYGON command
     
    R.K. McSwain, Feb 24, 2005
    #2
  3. Found it, comes with Autodesk Map.
    No use in 2002 however.

    Jan
     
    Jan van de Poel, Feb 24, 2005
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.