graphics consideration

Discussion in 'SolidWorks' started by neil, Mar 22, 2006.

  1. neil

    neil Guest

    hey ho all,
    after months of enduring random lockups that I could not pin down I have
    thrown my graphics card into the rubbish bin in frustration - a quadro 750 -
    and borrowed a FX5200 to keep me semi functional while I sort out a decent
    replacement.
    Now here is the issue- In NZ to replace this card with same will cost about
    $550 - about the same cost as a 7800GS.
    Now I know all about using Quadros for CAD but I am thinking ahead to when I
    replace my hardware soon and what I might do with the present pc.
    If I stick a gaming card in it will be more likely to interest a local buyer
    when the time comes.
    So is there anyone out there who has run SW with a 7800GS who can reassure
    me that it is not ideal but will be ok in the interim? or are there real
    issues to avoid?
    I realise no realview or buffer will be available.
    BTW I run 2 monitors in span mode for SW2005.Just a few windows open is ok.
    thanks for any feedback
    neil
     
    neil, Mar 22, 2006
    #1
  2. neil

    neil Guest

    thanks for the reply Big Al,
    The 7800GS should be a significantly faster than the 750XGL at the res I
    drive the screen at - 2560x960- being a couple of generations on development
    wise. Even with known limitations for CAD purposes I am hopeful it will do
    for a while anyway.
    I found some mention of the 7800GTS on SW forum where it was described in
    someone's experience as ok but lacking clarity in comparison to a dedicated
    card. Don't know about that - possibly more of a driver issue- but I think
    all said and done it will probably be better than the 750 (minus realview of
    course). The only concern I have is that I might have niggling driver issues
    with SW.
    I'll do a bit more research tomorrow and make a choice...
    thanks again
    -neil
     
    neil, Mar 23, 2006
    #2
  3. neil

    neilscad Guest

    For those interested - anyone? :eek:) - I bought a 6800 GS agp in the end
    and after a bit of hassle with installing a driver with XP I am using
    the softmod to enable a quasi Quadro FX4000. Draws less power from my
    ps than the 7800.It will do in the meantime....
    Seems only a bit faster than the old quadro 750 in general but now I
    can use full 16x antialiasing too at 2560x960 with no real perf drop.
    later-
     
    neilscad, Apr 15, 2006
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.