Geometric Tolerancing Dimensions

I note that within a part sketch you can modify the dimension text and
add certain symbols that remain attached to the dimension when brought
into a drawing. None of the symbols are of the geometric tolerance
type. When geometric tolerance dimensions are added as annotations,
and a drawing is created, they are not associated with any dimensions.

Is there a way to add these tolerances as text so that they will move
with the drawing dimension?

 

Not that I know of, but that was one of the 2005 teasers - you can "attach"
a note to a dimension so it travels with it.

WT

 

You can use a GD&T font, but it may not be possible to use such with
dimensions per se. Using them with notes should be easy enough. There
are some free ones out there (http://www.i-logic.com/imsfont.htm) and
there are some cheap ones that are probably better than the free ones
(http://www.cybermetrics.com/GDTFont/GDT_OVR.HTM).

Best regards,
Mark 'Sporky' Stapleton