GAP TOLERANCE IN BOUNDARY HATCH

Discussion in 'AutoCAD' started by TUSHAR PATEL, Mar 30, 2005.

  1. TUSHAR PATEL

    TUSHAR PATEL Guest

    I HAVE SET MY GAP TOLERANCE IN THE BOUNDARY HATCH DIALOG BOX = 10units

    NOW MY GAP DURING HATCH IS EQUAL TO 5mm

    SO I WILL GET THE MESSAGE DURING CREATION OF HATCH THAT " CLOSE BOUNDARY NOT FOUND ETC." & AT LAST I HAVE ONE CHECK BOX WITH MESSAGE "REMEMBER THIS DECISION " IF I ON THAT CHECK BOX NOW AUTOCAD WILL NEVER ASK ME ABOVE MESSAGE IF MY GAP IS LESS THAN THE GAP TOLERANCE.

    "BUT IF I WANT THAT MESSAGE AGAIN" WHAT IS THE WAY? IS THERE ANY SYSTEM VARIABLE? PLEASE. HELP ME OUT OF THIS PROBLEM........
     
    TUSHAR PATEL, Mar 30, 2005
    #1
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. HATCH boundary objects - reverse engineering

  2. Area and Centroid of Hatch or Boundary with islands

  3. BREAK lines with gap

  4. Dim. Extension Gap form Center Mark

  5. Maximum edge gap bug?

  6. How to design the clearance(gap) between mating surface

  7. Hide "Hatch boundary associativity removed"

Loading...