Forming Tools

Discussion in 'SolidWorks' started by Richard Charney, May 4, 2005.

  1. Richard Charney

    Richard Charney Guest

    Does anybody else have trouble placing forming tools on a sheet metal part?
    It keeps on asking me if I want to make a 'Derived Part' when I place it on
    my sheet metal part.

    I'm using 2005 SP1.1

    Richard
     
    Richard Charney, May 4, 2005
    #1
  2. Richard Charney

    Sean-Michael Adams Guest

    Hi Richard -

    Are you pulling it off of the "forming tools" pallette or off of the
    regular palette?

    That might be an issue for these - something to confirm.

    Later,

    SMA
     
    Sean-Michael Adams, May 4, 2005
    #2
  3. Richard Charney

    remy martin Guest


    Make sure folder is "checked" (rmb) as a forming tools folder.
     
    remy martin, May 4, 2005
    #3
  4. Richard Charney

    Richard Charney Guest

    That was it.

    Thanks for your help.

    Richard



     
    Richard Charney, May 4, 2005
    #4
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Breaking News ... Accellera Verification Working Group Forming

  2. Concrete Forming

  3. Forming Tools

  4. Sheet Metal Forming Tools - Surfaces Simulate The Part

  5. Why aren't my sheet metal forming tools working in SW 2006?

  6. Forming Tools

  7. Forming Tools

  8. Sheet metal and forming tools

Loading...