Font sizes

Discussion in 'SolidWorks' started by Oneball, Oct 18, 2007.

  1. Oneball

    Oneball Guest

    Sorry, this may be beneath some of you. I'm looking for some
    information on proper font sizes to use in drawings. Specifically the
    size and type to place on my detail view callout. Any help would be
    greatly appreciated.
     
    Oneball, Oct 18, 2007
    #1
  2. Oneball

    iQ Guest

    Minimum Letter Heights
    Drawing Title, Drawing Size .24
    Cage Code, Drawing Number and Revision Letter (When used within the
    Title Block) .12
    Section and View Letters .24
    Zone Letters and Numbers in Borders Drawing Block Headings .10
    All Other Characters .12

    This is from the Modern Drafting Practices and Standards Manual from
    Genium Publishing.

    I use this manual as a baseline to my engineering standards and i
    write deviations to our internal standard. iQ
     
    iQ, Oct 18, 2007
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Tool Palette Image - multiple sizes?

  2. Making file sizes smaller ??

  3. SWX 2004 file sizes

  4. Any way to propogate the Font sizes to multiple sheets?

  5. disable certain hole wizard tapped hole sizes?

  6. Font substitution even though font is present

  7. SHX font to True Type font mapping

Loading...