Fluorescent tubes

Discussion in 'SolidWorks' started by Martin, May 15, 2005.

  1. Martin

    Martin Guest

    Any suggestions as to how to best handle rendering fluorescent tubes with
    PW?

    I have an assembly with several white 5mm diameter tubes, about 20 inches
    long.

    One light at each end?

    I'm working on this tomorrow and have a bunch of ideas to try out. I'll
    probably just try with a single tube by itself and move on to the assembly
    after I get it right.

    This is a case where it would be nice to have lights that become integral to
    a part.

    Thanks,

    -Martin
     
    Martin, May 15, 2005
    #1
  2. Martin

    jjs Guest

    On Sun, 15 May 2005 07:13:21 GMT, "Martin" <>
    wrote:

    I just set the material to 'constant; and make it white as a starting
    point. But I am not looking for ultra realism in the rendering I do
    using this technique.

    Jonathan
     
    jjs, May 15, 2005
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Lines to tubes

  2. Designing with tubes

  3. tubes and cosmos analysis

  4. drwg 3-D tubes w/ radii using extrude & pathcurve

Loading...