Flat Dimensioning In AutoCAD 3D

Discussion in 'AutoCAD' started by Choong, Mar 20, 2007.

  1. Choong

    Choong Guest

    Hi everyone, I need some help, what I need to know is how to do a flat
    dimensioning under 3D condition so that my dimensioning lines are in a
    flat mode just like how it should be when we are doing it under normal
    2D condition, any help please and appreciate it much.

    Thanks
    Choong
    Malaysia
    KL
     
    Choong, Mar 20, 2007
    #1
  2. Choong

    longshot Guest

    use viewports & set your object flat in each view
     
    longshot, Mar 20, 2007
    #2
  3. Choong

    Choong Guest

    Hi all, i have made some mistaken steps in my drawing that now the two
    components are joined together and seParate command fails to separate
    them into two independant block so is there anyway out of this? Any help
    is very much appreciated.

    Thanks

    Choong
    Kuala Lumpur
    Malaysia
     
    Choong, May 8, 2007
    #3
  4. Choong

    hpspt Guest

    Hello
    You can only separate parts which are not in contact. Otherwise you need to
    use "section" command to cut the object or make a boolean subtract operation
     
    hpspt, May 8, 2007
    #4
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Flat Verilog netlist - out

  2. mapping vector names to flat netlist nodes

  3. lvs flat mode problem

  4. Flat mode extraction error !!!

  5. How do I create a flat spectre netlist from the ADE?

  6. How to flat layout??

  7. Unilateral Dimensioning in Autocad 2000

Loading...