Fit Tolerances disapeared on me

Discussion in 'SolidWorks' started by John Layne, Mar 16, 2005.

  1. John Layne

    John Layne Guest

    Hi

    On trying to dimension a shaft with a "Fit with Tolerance" I get the
    following error no matter which tolerance size I select.

    "No tabulated tolerance values or classification found for the selected
    Shaft Fit type"

    I think there must be a setting that I have screwed up somewhere under
    "Options"
    "System Options"
    "File Locations"

    But I can't figure it out, please gimmie a clue?

    John Layne
    Solid Engineering Ltd
     
    John Layne, Mar 16, 2005
    #1
  2. John Layne

    John Layne Guest

    VAR came to the rescue, well kinda

    Quoted text below

    Problem Resolution:
    Technical Support Alert: Problem with shaft fit tolerances in 2005 SP1.1
    When selecting shaft fit dimension tolerance in 2005 SP1.1 you will
    see the message, 'No tabulated tolerance values or classification found
    for the selected shaft fit type'. The Problem Report for this issue is
    as follows:

    SPR 255197 Unable to apply shaft fit tolerance values

    This problem will be resolved in 2005 SP2.
     
    John Layne, Mar 16, 2005
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.