first models with design table

Discussion in 'SolidWorks' started by Guest, Jun 3, 2008.

  1. Guest

    Guest Guest

    I know it is not standard practice to model the threads on a bolt or screw
    but I thought it would be a good exercise. These are my first models using a
    design table to enter the parameters diameter, pitch, length, width across
    the flats and height. The models were done with the student edition of
    SolidWorks 2007. I will probably do the same exercise with the student
    edition of AutoDesk Inventor 2008. The solid models can be moved to and from
    AutoCAD, Inventor and SolidWorks via the ACIS file.

    This one is for a short bolt with a finished hex head, full length threads

    http://geocities.com//0.2500-20UNC-2A_x_0.5000_FIN_HEX_BOLT.SLDPRT

    this one is for a long bolt with a finished hex head, threads shorter than
    the length of the bolt.

    http://geocities.com//0.2500-20UNC-2A_x_1.0000_FIN_HEX_BOLT.SLDPRT

    Bolt
     
    Guest, Jun 3, 2008
    #1
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Question about First Encounter => Spectre design flow

  2. first RF circuit design?

  3. Design table generated assembly does not stick to its table parameters inside another assembly

  4. Problem with Design Table

  5. Gauge Table & Design Table

  6. Drawing table values linked to values in design table?

  7. TABLE:copy cell with references to another table

Loading...