Filter Paper Sizes not saving with PC3

I was wondering where the Filter Paper Sizes settings are saved as it
doesn't seem to be in the PC3.

I'm trying to distribute PC3 files across our network so everybody has the
same plotter setups, all the other settings seem to work fine when the .pc3
file is copied to another computer.

I'm running both LDD 2i and ALD 2004 with a mix of 2000pro and XPpro
computers.
The two plotters I'm trying to configure these for are a HP1050c and a
Ricoh7030

Thanks, Mark

 

Hmmm, shooting from the hip on this one. Check the length of the plotter
names. If I remember correctly if they are too long it wont save that stuff.

 

Thanks for the replies!

I found out that the filtered paper sizes are stored in the PMP file, and if
you look at the listing in the 2004 Plotter Configuration Editor - Device
and Document Settings tab
The "User-defined paper sizes & calibration" section is all stored in the
PMP file.

I'll have to do some more testing but I think that the driver for the 1050c
is compatible with both Windows2k and XP making the PC3 file compatible with
both, right? Still may have to make a separate one for 2i and 2004

Mark

stuff.