filter in DWGeditor

Discussion in 'SolidWorks' started by Not Necessarily Me, Sep 1, 2005.

  1. Help doesn't help much at all on the FILTER or DDFILTER command. I was
    expecting something like AutoCAD's filter command which allows you to filter
    selected items from a selection set. I was planning on writing a LISP
    routine that would separate out the flat sheetmetal pattern from the rest of
    the drawing elements. But without a workable FILTER I can't figure out how
    to erase the dimensions and dashed lines that are on the flat pattern view.
    Any insight appreciated but note that my abilities are limited to Autolisp..
     
    Not Necessarily Me, Sep 1, 2005
    #1
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.