Fillet question

HI,

In the sketch mode how do I draw a corner radius
with two different radius's, ie not equal?


thnanks,

Dennis

delete "lyx" to respond with email

 

Not sure I understand but....

Using the line sketch tool, draw a vertical line, switch to arc mode (by
pressing a or mousing back over the last endpoint and pulling away), draw
your first arc, click to end it, keep drawing your second arc, trying to
approximate the general scale and position you want. Switch back to line
mode, draw your horizontal line.

Now use the dimension tool to define a different radius for each arc.
Assign tangency between arcs and lines if not already there.

Zander

 

Dennis,
Either fillet one corner. ESC out of the fillet command. Then start
the fillet command again, but this time change the fillet dimension to
the new value.

---OR---

Fillet both, then ESC out of the fillet command. Now remove the
"Equal" (or is it "Equal to"?) relation between the 2 fillets. Now
you can dimension them sepatately.

Is that what you're looking for?
Ken

 

Yes, that did it.

thanks,

Dennis

 

Well try the Arc sketch feature, wy not ?